Results 1 - 10 of 77

• Roof Span Design for Underground Stone Mines
  7/1/2010 - Conference papers
  In this paper, the findings of a survey of roof span stability issues and design practices are presented, and the observed factors contributing to roof instability are discussed.
• Performance Characteristics for Welded Wire Screen Used for Surface Control in Underground Coal Mines
  2/1/2009 - Conference papers
  The load-deformation characteristics and the load capacity of welded wire screen (roof screen) used to control ground fall were evaluated in the laboratory in a specially built test frame.
• Development and Application of the Coal Mine Roof Rating (CMRR)
  5/1/2007 - Conference papers
  This paper discusses the sources used in developing the CMRR, describes the CMRR data collection and calculation procedures, and briefly presents a number of practical mining applications in which the CMRR has played a prominent role.
• Ground Control Design for Highwall Mining
  2/1/2005 - Conference papers
  Highwall stability remains a major concern during highwall mining. Geologic structure (hillseams) and pillar stability are the two major factors affecting highwall stability.
• Analysis of Practical Ground Control Issues in Highwall Mining
  8/1/2004 - Conference papers
  This article discusses highwall stability, reasons for early pull out of highwall miner holes, and geotechnical engineering and planning factors, as well as operating practices to improve highwall stability and minimize the risk of a trapped miner.
• Applications of the Point Estimation Method for Stochastic Rock Slope Engineering
  6/1/2004 - Conference papers
  The point estimation method for the probability of sliding is efficient and expedites slope stability simulation routines in NIOSH software to stochastically describe rock slope behavior and assist engineers in catch bench design for large slopes.
• Performance of Roof Support Under High Stress in a U.S. Coal Mine
  2/1/2004 - Conference papers
  The primary goal of this project was to obtain detailed data on the interaction between the mine roof and the support elements for use in modeling studies. 
• Mistakes, Misconceptions, and Key Points Regarding Secondary Roof Support Systems
  8/1/2001 - Conference papers
  This paper discusses misconceptions about how roof supports perform and factors that impact their performance. The paper is limited to a discussion of secondary roof support systems and powered roof supports such as longwall shields.
• Toward Pillar Design To Prevent Collapse of Room-and-Pillar Mines
  2/1/2001 - Conference papers
  Three alternative approaches to reduce the risk of catastrophic collapse are described: containment, prevention, and full-extraction. Without good data available on post-failure pillar behavior, containment and full-extraction are the safest.
• Optimizing Secondary Roof Support with the NIOSH Support Technology Optimization Program (STOP)
  8/1/2000 - Conference papers
  The 1990s saw an unprecedented increase in technologies for more effective, easier to install roof support in underground mines. To facilitate application and improve mine safety, NIOSH developed the Support Technology Optimization Program (STOP).